Spoon Holder

STEP 1:-

Mix Non Sticky Shilpkar Resin Base and Hardener to form an even dough and roll it into a slab
Make six small rectangular slabs little larger in size than the design selected for the handles of the spoon

STEP 2:-

Trace the design on the slabs using a carbon paper
Make the grooves deeper using a blunt tip of a pencil
Attach another slab of the same size on the reverse side keeping a gap for the spoon handle to fit in properly
Leave it to dry.

STEP 3:-

Mix Shilpkar Resin Base and Hardener and make a rectangular slab of 20'' long and 4'' in height
Fold the slab at an equal distance length wise and make it into a spoon holder
Attach a square slab from one side for the base of the spoon holder

STEP 4:-

Trace another 4 slabs with the Mayan characters proportionate to the sizes of the spoon holder and make deeper grooves using a pencil with a blunt tip
Stick the characters on the 4 walls of the spoon holder

STEP 5:-

Colour the spoon holder by mixing Sparkling Pearl Colours Golden Green and Golden Black
Leave it to dry

STEP 6:-

Also colour the spoon ends by mixing Sparkling Pearl Colours Golden Green and Golden Black
Leave it to dry

STEP 7:-

Fix the spoon ends to the spoons using No Stitch Fabric Glue

Fevicryl Non Sticky Shilpkar, Fevicryl Sparkling Pearl Colours - Golden Green 911, Golden Black 917, Fevicryl No Stitch fabric Glue Pencil, Eraser, Paper Cutter, Rolling Pin, A4 sized Drawing Sheet, Red Carbon Paper