Take a empty and clean glass bottle and wind jute cord all round the bottle. Cover the bottle completely without any gaps. Stick using Fevicryl No Stitch Fabric Glue. Leave to dry.

To make one jute / burlap flowers, take jute fabric and mark 20 inches X 3 inches panel on it. Peel off the plastic lining from the backside of the jute fabric. Take Fevicryl No Stitch Fabric Glue and apply a thick line on the lengthwise border of the marked jute panel (20 inches top and bottom border). Refer picture Leave to dry completely.

Slowly remove the lengthwise jute yarns from between the two border lines. Refer picture.

Apply Fevicryl No Stitch Fabric Glue on top border. Refer picture.

Fold lengthwise and stick the bottom border on the top border. Refer picture. You can use cloth pins to hold both the borders in place while the glue dries. Leave to dry completely.

Apply Fevicryl No Stitch Fabric Glue on the border and start rolling from one end. Refer picture.

Continue rolling till the end. Refer picture.

You will get a jute/ burlap flower. Leave to dry.

This would be the side view of the flower.

Draw and cut few leaves of different sizes from the jute fabric. (Do not peel off the plastic lining from the backside of jute fabric) Border each leaf by sticking jute cord using Fevicryl No Stitch Fabric Glue. You can paint the jute cord using Fevicryl Pearl Metallic Colour- Gold, if you want a golden border to the leaves. Leave to dry.

Stick the leaves on the jute bottle (you had prepared bottle in step 1) using Fevibond. Stick only the tip and base of the leaves. Refer picture. Stick 2 to 3 rounds of jute cord at the base to cover the leaf base using Fevibond. Stick the flowers on the bottle using Fevibond. Stick decorative stones in the center of flowers using Fevicryl No Stitch Fabric Glue. Refer picture. Leave to dry.